#
# Set any special options here.  Most drivers will autoprobe/autoIRQ
# if you set the address or IRQ to zero, so we do that by default.
# Cards and options supported:
#
#  EI_DEBUG		Set the debugging level for 8390-based boards
#  CONFIG_WD80x3	The Western Digital (SMC) WD80x3 driver
#	WD_SHMEM=xxx	Forces the address of the shared memory
#	WD_no_mapout	Don't map out the shared memory (faster, but
#			your machine may not warm-boot).
#  CONFIG_NE2000	The NE-[12]000 clone driver.
#	PACKETBUF_MEMSIZE  Allows an extra-large packet buffer to be
#			used.  Usually pointless under Linux.
#	show_all_SAPROM  Show the entire address PROM, not just the
#			ethernet address, during boot.
#	rw_bugfix	Patch an obscure bug with a version of the 8390.
#  CONFIG_HPLAN		The HP-LAN driver (for 8390-based boards only).
#	rw_bugfix	Fix the same obscure bug.
#  CONFIG_EL1		The 3c501 driver (just joking, never released)
#  CONFIG_EL2		The 3c503 EtherLink II driver
#	EL2_AUI		Default to the AUI port instead of the BNC port
#	no_probe_nonshared_memory  Don't probe for programmed-I/O boards.
#	EL2MEMTEST	Test shared memory at boot-time.
#  CONFIG_EL3
#	EL3_DEBUG	Set the debugging message level.
#  CONFIG_AT1500
#	LANCE_DEBUG	Set the debugging message level.
#	DEFAULT_DMA	Change the default DMA to other than 5.
#  CONFIG_PLIP		The Crynwr-protocol PL/IP driver
#  SLIP			The MicroWalt SLIP driver
#	  SL_DUMP	Uses the "dump frame" debug code
#	  SL_COMPRESSED Use CSLIP
#  D_LINK		The D-Link DE-600 Portable Ethernet Adaptor.
#	  D_LINK_IO	The D-Link I/O address (0x378 == default)
#	  D_LINK_IRQ	The D-Link IRQ number to use (IRQ7 == default)
#	  D_LINK_DEBUG	Enable or disable D-Link debugging
#

# This is at the top level with 'make config'
CARDS =


OPTS		= #-DEI8390=0 -DEI8390_IRQ=0
WD_OPTS		= #-DWD_SHMEM=0
EL2_OPTS	= #-UEL2_AUI
NE_OPTS		=
HP_OPTS		=
PLIP_OPTS	=
SLIP_OPTS	= -DSL_DUMP -DSL_COMPRESSED
DL_OPTS		= -DD_LINK_IO=0x378 -DD_LINK_IRQ=7 -UD_LINK_DEBUG
AT_OPTS		= # -DLANCE_DMA=5
